,%202x,%2024WxL15,%20Microfit3.0,%20Microfit3.0,%200.4mm)?unique=d59141b)
,%202x,%2024WxL15,%20Microfit3.0,%20Microfit3.0,%200.4mm)?unique=d59141b)
Customizable Kit Prusa Mini DHB D3x22.5 Drop In Replacement kit
Boost your Prusa Mini. Add your choice of nozzle output, 24/30W heater...
For an easy change over, the original heat sink (Most expensive part!) has been modified to integrate the Starlex DHB 22.5mm.
Wiring will need to be adapted for MCH Heater and Thermistor (NTC 100K 3950 - JST gh1.25)
Easiest upgrade, use a 4pins screw connector.
Always bring both MCH wires to the back horizontally, give them enough space to move freely !
Do not forget to print the STL file below.
This upgrade will greatly enhance the melt zone similar to a Volcano nozzle while preserving the original height.
Both heater wires will come to the right, behind the gap of the heat sink and the thermistor wire also to the right. The heater wires should never be locked, they must have as much freedom as possible to avoid forcing on the soldering point.
No other mechanical modifications necessary.
Wiring will need to be adapted for MCH Heater and Thermistor (NTC 100K 3950 - JST gh1.25)
Easiest upgrade, use a 4pins screw connector.
Always bring both MCH wires to the back horizontally, give them enough space to move freely !
Do not forget to print the STL file below.
This upgrade will greatly enhance the melt zone similar to a Volcano nozzle while preserving the original height.
Both heater wires will come to the right, behind the gap of the heat sink and the thermistor wire also to the right. The heater wires should never be locked, they must have as much freedom as possible to avoid forcing on the soldering point.
No other mechanical modifications necessary.
Documents
Terms and Conditions
14 days return, money-back guarantee
Shipping: 2-7 Business Days
Your Dynamic Snippet will be displayed here...
This message is displayed because youy did not provide both a filter and a template to use.