Full Kit, BambuLab Voron, Starlex DHB D3.0x24, 4x HSS+C Nozzle Set, 2x MCH 30W 24V Heaters, 1x Thermistor NTC 100K 3950 Microfit 3.0

Starlex DHB is a game changer for tool free nozzle swap in seconds.

No material leak as the extremity is located into the cold section, in the heat sink.

Chose from brass or hardened stainless steel nozzle, without the hassle of connectors and tools.

BambuLab Clone Heat Sink with HSC and Base Plate

Starlex DHB 3.0x24 Hotend Base Set

2x MCH 24V 30W heaters and NTC 100K 3950 Thermistor with Microfit 3.0 connector.

Choice of HSS+C nozzles

It does not include the 2x Microfit 1m long wires to connect the MCH heaters & Thermistor to the board.

The 2.5mm nozzles are made of stainless steel, hardened to withstand abrasive filaments and high temperatures.

They have an external diameter of 2.5mm to reduce the thermal barrier due to the low thermal conductivity of the metal used.

Heat blocks should match nozzle diameter D2.5mm.

Light increase of standard temperature (+5 to 10°C) can be needed to keep up with flow rate or more depending on your filament quality.  

Some specifically abrasive filaments will wear down the hardened nozzle over time.

Brass and HSS copper sleeve nozzles have an external diameter of 3.0mm.

Heat blocks must match nozzle diameter D3.0mm

It does not include the 2x Microfit 3.0 1m long wires to connect the MCH heaters & Thermistor to the board.