Skip to Content

Bambu Lab

BambuLab is a great new generation 3D printer FDM that have been developed with amazing performances. We love it.

These performances are also in the hot-end section where they managed to do a light hot-end with high temperature efficiency and 24mm melt zone.

The Starlex DHB 24 with the adapted clone heat sink is a stand alone replacement option.

For the thermal efficiency, the Starlex DHB will perform better with two 30W MCH heaters, one on each side to reach fast heating performances.

For a nozzle change over, it will make the difference. With our protruded nozzles (soon available), it will boost your flow performances.

As different brands propose for BambuLab parts between 48 and 60W heaters, by deduction, it would determines the maximum wattage rating the electronics would support. 

It is at your own risk to mount higher power heaters than 2x 30W, the risk is to burn your circuit board or other parts, knowing that the main power supply is rated 100W only for the printer.

1rst print on the BBL P1S... https://www.instagram.com/reel/C5RK2dWtop_/?utm_source=ig_web_copy_link&igsh=MzRlODBiNWFlZA==

Simple Drop In replacement for X1C & P1P - P1S 3D Printers, change your nozzle in seconds...

X1-Carbon

Drop In replacement kit, same height, same Thermistor, 2x MCH Heaters 30W 24V with Y JST 2.54 Harness

P1P - P1S

Drop In replacement kit, same height, same Thermistor, adapted original connector with 2x MCH 30W 24V Heaters

Heaters & Thermistor X1C

2x 30W 24V Heaters JST XH 2.54

1x NTC 100K 3950 Thermistor

1x Harness JST XH 2.54

Heaters & Thermistor P1P-P1S

2x 30W 24V Heaters

1x NTC 100K 3950 Thermistor