Starlex DHB Shop
Heat Sink Connector Spacer
In red, (2) this specific part is needed when an original heat sink / direct drive is used to adapt the Starlex DHB hot-end to it. Usually 1.5mm height.
To integrate the Starlex DHB hot-end, both sides of the heat blocks need to move freely. Between the Heat Sink (1) and the Base Plate (3), a space (O) is necessary to give freedom to the heaters side movement.
The HSC (4) needs to be adapted for this extra space.
The spacer can be a cylinder or a machined aluminium plate, depending on Heat Sink and Heat Sink Connector size.
Select the correct Heat Sink Connector (HSC), and the corresponding Heat Sink Connector Spacer (HSCS), central hole must match.
No product defined
No product defined in this category.
All Swiss3Dc designed parts are made and produced in Switzerland, standard parts can be imports.
The colors of the parts on the images in the shop and on the website are for differentiation purposes only.
WARNING ⚠️: Some products sold on this website can expose you to chemicals, including Mineral Oils, which is known to the State of California to cause cancer, also Lead and Nickel, that are known to the State of California to cause cancer and birth defects or other reproductive harm. More information: https://www.p65warnings.ca.gov/